Synaccess Networks NP-0801DTM - Manual (Page 96)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 96
Read command reports the currently selected <mode> in the format:
+CCWE: <mode>
Test command reports the supported range of values for parameter <mode>.
Syntax
Command Command type
AT+CCWE=<mode> Set
AT+CCWE? Read
AT+CCWE=? Test
Parameters and Values
<mode>
0 Disable call meter warning event. Default: 0.
1 Enable call meter warning event.
Set Voice Mail Number +CSVM
This command sets the number to the voice mail server. If the parameter <mode> is set to 0, you can omit the
parameters <number> and <type>.
Read command returns the currently selected voice mail number and the status (that is, enabled or disabled) in
the format
+CSVM:<mode>,<number>,<type>
Test command reports the range for the parameters <mode> and <type>.
Syntax
Command Command type
AT+CSVM= <mode> [,<number>[,<type>]] Set
AT+CSVM? Read
AT+CSVM=? Test
Parameters and Values
<mode>
0 Disable the voice mail number
1 Enable the voice mail number. Default: 1.
<number> String type, phone number of format specified by <type>.
<type> Type of address octet in integer format.
129 Unknown type of number and ISDN/Telephony numbering plan.
145 International type of number and ISDN/Telephony numbering plan. Contains the
character "+".
Note: Set command only checks for parameters values validity. The command
does not actually write to SIM to update voice mail number.