Synaccess Networks NP-0801DTM - Manual (Page 301)

GPS AT COMMANDS SET
301 HSPA+ AT Commands Reference Guide
Parameters and Values
<mode>
0 Disable unsolicited. Default: 0.
1 Enable unsolicited.
The unsolicited result code is in the format:
$LICLS: <request_type>[,<cid>]
where
<request_type>
0 – Setup request to setup the control link.
1 – Release request to release the control link.
<cid> : ID associated to the context that is deactivated (see +CGDCONT).
If the <request_type> is a setup request, the unsolicited indication is sent/used to
request the client to define, setup, activate and prepare the pdp‐context.
If <request_type> is a release request, the unsolicited indication is sent/used to
inform the client that the pdp‐context (associated with this command type)
including the associated terminal is not used any more, and is deactivated.
MT Location Request Mode $LCSLRMT
Set command enables or disables unsolicited $LCSLRMT response.
Read command returns the current value of parameter <mode>.
Test command returns the range of values for parameter <mode>.
Syntax
Command Command type
AT$LCSLRMT= <mode> Set
AT$LCSLRMT? Read
AT$LCSLRMT=? Test
Parameters and Values
<mode>
0 Disable unsolicited. Default: 0.
1 Enable unsolicited.
Notes
The unsolicited result code is in the format:
$LCSLRMT: <transport_protocol>,<Notif_type>,<Loc_estimate_type>,<Client_Id>,<Client_NameEncoding_type>,
<Client_Name_Type>,<Client_Name>,<Requestor_Id_Encoding_type>,<Requestor_Id_Type>,
<Requestor_Id>,<Codeword>,<Service_Type_id>,<reqid>
where: