Synaccess Networks NP-0801DTM - Manual (Page 180)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 180
Parameters and Values
Need to complete this section? 1‐15, 1, and 2 which are blank get removed
FYI what this section means: value is a number between 0 & 15
Basically there are 5 values which can be set individually or in combination with each other.
0
1
2
4
8
0 means disabled
You can enable setting 1, 2, 4, or 8 individually, or combine them.
If you want to enable function 2&4 you set value of 6 (2+4=6.) If you want to enable everything you set a value of 15
(1+2+4+8=15)
So enabling everything is why the max value is 15
You need to come up with words to describe that. Concept is the same as +WIND description in our other documents.
<val> You can enable settings of 1, 2, 4, or 8 individually, or combine them by adding
values.
For example, if you want to enable functions 2 and 4, set a value of 6. To enable
all functions, set a value of 15.
Default: 7.
0 Disables (a) automatic data/time updating, (b) Full Network Name applying and
(c) #NITZ URC; moreover it sets the #NITZ URC ‘basic’ format. See <datetime> in
the <mode> description that follows.
1 Enables automatic date/time updating.
2 Enables Full Network Name applying.
4 Sets the #NITZ URC ‘extended’ format. See <datetime> in the <mode> description
that follows.
8 Sets the #NITZ URC ‘extended’ format with Daylight Saving Time (DST) support.
See <datetime> in the <mode> description that follows.
<mode>
0 Disables #NITZ URC. Default: 0.
1 Enables #NITZ URC; after date and time updating the following unsolicited
indication is sent:
#NITZ: <datetime>
where:
<datetime> ‐ string whose format depends on subparameter <val>.
“yy/MM/dd,hh:mm:ss” ‐ ‘basic’ format, if <val> is in (0‐3).