Synaccess Networks NP-0801DTM - Manual (Page 164)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 164
call, and is displayed as 255.
<ecio> Chip energy per total wideband power in dBm; for serving cell this is not available
during a call, and is displayed as 255.
<uarfcn> UMTS assigned radio channel.
<drx> Discontinuous reception cycle length.
<scr> Scrambling code.
Note: TA: <timadv> is reported only for the serving cell.
If the last setting done by #MONI is 7, the Execute command produces a table‐like formatted output, as follows:
„
First row reports the identifying name of the ‘columns’
#MONI: Cell BSIC LAC CellId ARFCN Power C1 C2 TA RxQual PLMN<CR><LF>
„
Second row reports a complete set of GSM‐related information for the serving cell:
#MONI: S: <bsic> <lac> <id> <arfcn> <dBm> <C1value> <C2value> <timadv> <qual> <netname><CR><LF>
„
3rd to 8th rows report a reduced set of GSM‐related information for the cells in the neighbours:
#MONI: N<n> <bsic> <lac> <id> <arfcn> <dBm> <C1value> <C2value>[<CR><LF>]
where:
<C1value> C1 reselection parameter.
<C2value> C2 reselection parameter.
Other parameters are described earlier.
Note: Currently, AT#MONI=7 is only available in case of GSM network.
Test command reports the maximum number of cells, in the neighbor list of the serving cell excluding it, from
which GSM/UMTS‐related information can be extracted, along with the ordinal number of the current selected
cell, in the format:
#MONI: (<MaxCellNo>,<CellSet>)
where:
<MaxCellNo> Maximum number of cells, in the neighbor list of the serving cell and excluding it,
from which GSM‐related information can be extracted. This value is always 6.
<CellSet> Last setting done with command #MONI.
Syntax
Command Command type
AT#MONI[=[<number>]]
AT#MONI=?
Parameters and Values
<number>
GSM network
0‐6 The ordinal number of the cell, in the neighbor list of the serving cell. Default: 0,
serving cell.
7 Special request to obtain GSM‐related information from the whole set of seven
cells in the neighbor list of the serving cell.