Synaccess Networks NP-0801DTM - Manual (Page 33)

HAYES COMPLIANT AT COMMANDS
33 HSPA+ AT Commands Reference Guide
Identification Information I
Execute command returns one or more lines of information text followed by a result code.
Syntax
Command Command type
ATI[<n>] Execute
Parameters and Values
<n>
0 Numerical identifier.
1 Module checksum.
2 Checksum check result.
3 Manufacturer.
4 Product name.
5 DOB version.
Notes
„
If parameter is omitted, the command has the same behavior as ATI0.
„
Reference: V.25ter.
Data Carrier Detect (DCD) Control &C
Set command controls the RS232 DCD output behavior.
Syntax
Command Command type
AT&C[<n>] Set
Parameters and Values
<n>
0 DCD remains high always.
1 DCD follows the Carrier detect status: if carrier is detected DCD is high, otherwise
DCD is low. Default: 1.
2 DCD off while disconnecting.
Notes
„
If parameter is omitted, the command has the same behavior as AT&C0.
„
Reference: V.25ter.
Data Terminal Ready (DTR) Control &D
Set command controls the module behavior to the RS232 DTR transitions.
Syntax
Command Command type
AT&D[<n>] Set