Enter pin +cpin, Read command, Syntax – Synaccess Networks NP-0801DTM User Manual
Page 75
3GPP TS 27.007 AT COMMANDS
75
HSPA+ AT Commands Reference Guide
Enter PIN +CPIN
Set command sends to the device a password which is necessary before it can be operated (SIM PIN, SIM PUK, PH‐
SIM PIN, and so on).
If the PIN required is SIM PUK or SIM PUK2, the <newpin> is required. This second pin, <newpin> Replace the old
pin in the SIM.
You can use the command to change the SIM PIN by sending it with both parameters <pin> and <newpin> when
PIN request is pending. If no PIN request is pending the command returns an error code and to change the PIN the
command +CPWD must be used instead.
Read command
Read command reports the PIN/PUK/PUK2 request status of the device in the form:
+CPIN: <code>
where:
<code>
PIN/PUK/PUK2 request status code.
READY
ME is not pending for any password .
SIM PIN
ME is waiting for SIM PIN.
SIM PUK
ME is waiting for SIM PUK
PH‐SIM PIN
ME is waiting for phone‐to‐SIM card password.
PH‐FSIM PIN
ME is waiting for phone‐to‐very first SIM card password.
PH‐FSIM PUK
ME is waiting for phone‐to‐very first SIM card unblocking password.
SIM PIN2
ME is waiting for SIM PIN2. This <code> is returned only when the last
executed command resulted in PIN2 authentication failure; that is, +CME
ERROR: 17.
SIM PUK2
ME is waiting for SIM PUK2. This <code> is returned only when the last
executed command resulted in PUK2 authentication failure; that is +CME
ERROR: 18.
PH‐NET PIN
ME is waiting for network personalization password.
PH‐NET PUK
ME is waiting for network personalization unblocking password.
PH‐NETSUB PIN
ME is waiting for network subset personalization password.
PH‐NETSUB PUK
ME is waiting for network subset personalization unblocking password.
PH‐SP PIN
ME is waiting for service provider personalization password.
PH‐SP PUK
ME is waiting for service provider personalization unblocking password.
PH‐CORP PIN
ME is waiting for corporate personalization password.
PH‐CORP PUK
ME is waiting for corporate personalization unblocking password.
Note: Pin pending status at startup depends on PIN facility setting. To change or query the default power up
setting use the command AT+CLCK=SC,<mode>,<pin>.
Test command returns OK result code.
Syntax
Command
Command type
AT+CPIN=<pin>[,<newpin>]
Set
AT+CPIN?
Read
AT+CPIN=?
Test