Synaccess Networks NP-0801DTM - Manual (Page 163)

CUSTOM AT COMMANDS
163 HSPA+ AT Commands Reference Guide
Execute command (AT#MONI<CR>) reports GSM/UMTS‐related information for selected cell and dedicated
channel (if exists).
If the last setting done by #MONI is in the range [0‐6], the output format is as follows:
„
When extracting data for the serving cell and the network name is known the format is:
GSM network
#MONI: <netname> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id> ARFCN:<arfcn> PWR:<dBm> dBm TA:
<timadv>
UMTS network
#MONI: <netname> PSC:<psc> RSCP:<rscp> LAC:<lac> Id:<id>EcIo:<ecio> UARFCN:<uarfcn> PWR:<dBm> dBm
DRX:<drx> SCR:<scr>
„
When the network name is unknown, the format is:
GSM network
#MONI: Cc:<cc> Nc:<nc> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id> ARFCN:<arfcn> PWR:<dBm> dBm TA:
<timadv>
UMTS network
#MONI: Cc:<cc> Nc:<nc> PSC:<psc> RSCP:<rscp> LAC:,<lac> Id:<id> EcIo:<ecio> UARFCN:<uarfcn>
PWR:<dBm> dBm DRX:<drx>SCR:<scr>
„
When extracting data for an adjacent cell, the format is:
GSM network
#MONI: Adj Cell<n> [LAC:<lac> Id:<id>] ARFCN:<arfcn> PWR:<dBm> dBm
UMTS network
#MONI: PSC:<psc> RSCP:<rscp> EcIo:<ecio> UARFCN:<uarfcn> SCR:<scr>
where:
<netname> Name of network operator.
<cc> Country code.
<nc> Network operator code.
<n> Progressive number of adjacent cell.
<bsic> Base station identification code.
<qual> Quality of reception.
0‐7
<lac> Localization area code.
<id> Cell identifier.
<arfcn> Assigned radio channel
<dBm> Received signal strength in dBm; for serving cell in UMTS network this is not
available during a call, and is displayed as 0.
<timadv> Timing advance.
<psc> Primary synchronisation code.
<rscp> Received Signal Code Power in dBm; for serving cell this is not available during a