Synaccess Networks NP-0801DTM - Manual (Page 42)

HAYES COMPLIANT AT COMMANDS
HSPA+ AT Commands Reference Guide 42
Parameters and Values
<char> Command line editing character (decimal ASCII).
0‐127 Default: 8. (ASCII BS).
Notes
„
Reference: V.25ter.
Connection Completion Time‐Out S7
Set command sets the amount of time, in seconds, that the device allows between either answering a call
(automatically or by A command) or completion of signaling of call addressing information to network (dialing),
and establishment of a connection with the remote device.
Read command returns the current value of S7 parameter. The format of the numbers in output is always 3 digits,
left‐filled with 0s.
Syntax
Command Command type
ATS7=[<tout>] Set
ATS7? Read
Parameters and Values
<tout> Number of seconds.
1‐255 Default: 60.
Notes
„
Reference: V.25ter.
S12
This command will be defined for a future release. The default for this command is 050.
Delay to DTR Off S25
Set command defines the amount of time, in hundredths of second, that the device ignores the DTR for taking the
action specified by command &D.
Read command returns the current value of S25 parameter. The format of the numbers in output is always 3
digits, left‐filled with 0s.
Syntax
Command Command type
ATS25=[<time>] Set
ATS25? Read
Parameters and Values
<time> Expressed in hundredths of a second.
0‐255 Default: 5.
Note: The delay is effective only if its value is greater than 5. Command not yet