Synaccess Networks NP-0801DTM - Manual (Page 222)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 222
<sendDataMode> Data mode for sending data in command mode(AT#SSEND).
0 Data represented as text. Default: 0.
1 Data represented as sequence of hexadecimal numbers (from 00 to FF).
Each octet of the data is given as two IRA character long hexadecimal number.
Notes
„
You must set the parameters with #SCFGEXT before establishing a data connection using the AT+SGACT
command.
„
These values are automatically saved in non‐volatile memory.
„
Keepalive is available only on TCP connections.
„
For the behavior of AT#SL and AT#SLUDP in case of auto‐response mode or in case of no auto‐response mode,
see the description of the two commands.
Examples
Socket 1 set with data view sring, text data mode, a keepalive time of 30 minutes and listen auto‐response set.
Socket 3 set with data amount sring, hex recv data mode, no keepalive and listen auto‐response not set.
Socket 4 set with hex recv and send data mode
at#scfgext?
#SCFGEXT: 1,2,0,30,1,0
#SCFGEXT: 2,0,0,0,0,0
#SCFGEXT: 3,1,1,0,0,0
#SCFGEXT: 4,0,1,0,0,1
#SCFGEXT: 5,0,0,0,0,0
#SCFGEXT: 6,0,0,0,0,0
OK
Socket Configuration Extended 2 #SCFGEXT2
Set command sets the socket configuration extended parameters for features not included in #SCFGEXT
command.
Read command returns the current socket extended configuration parameters values for all the six sockets, in the
format:
#SCFGEXT2:<connId1>,<bufferStart1>,0,0,0,0<CR><LF>
. . .
#SCFGEXT2:<connId6>,<bufferStart6>,0,0,0,0<CR><LF>
Test command returns the range of supported values for all the subparameters.