Synaccess Networks NP-0801DTM - Manual (Page 191)

CUSTOM AT COMMANDS
191 HSPA+ AT Commands Reference Guide
Codec Information #CODECINFO
This command is both a set and an execute command.
Set command enables or disables codec information reports depending on the parameter <mode>, in the
specified <format>.
Read command reports <format> and <mode> parameter values in the format:
#CODECINFO: <format>,<mode>
Test command returns the range of supported <format> and <mode>.
Syntax
Command Command type
AT#CODECINFO[=<format>[,<mode>]] Set
Execute
AT#CODECINFO? Read
AT#CODECINFO=? Test
Parameters and Values
<format>
0 Numeric format. Default: 0.
1 Text format.
<mode>
0 Disable codec information unsolicited report. Default: 0.
1 Enable codec information unsolicited report only if the codec changes.
2 Enable short codec information unsolicited report only if the codec changes.
If <mode>=1 the unsolicited channel mode information is reported in the following format:
(if <format>=0)
#CODECINFO: <codec_used>,<codec_set>
(if <format>=1)
#CODECINFO: <codec_used>,<codec_set1>
[,<codec_set2>[..[,codec_setn]]]
If <mode>=2 the unsolicited codec information is reported in the following format:
#CODECINFO: <codec_used>
The reported values are described below.
Execute command
Execute command reports codec information in the specified <format>.
(if <format>=0)