Synaccess Networks NP-0801DTM - Manual (Page 114)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 114
Examples
AT+CGACT=1,1
OK
AT+CGACT?
+CGACT: 1,1
OK
3G Quality of Service Profile (Negotiated) +CGEQNEG
This command allows the TE to retrieve the negotiated 3G quality of service returned in the Activate PDP Context
Accept/Modify message.
Set command returns the negotiated 3G QoS profile for the specified context identifiers, <cid>s. The QoS profile
consists of a number of parameters, each of which may have a separate value.
Test command returns a list of <cid>s associated with active contexts.
Syntax
Command Command type
AT+CGEQNEG=
[<cid>[,<cid>[,…]]] Set
AT+CGEQNEG=? Test
Parameters and Values
<cid> PDP context identification. See +CGDCONT.
Returns the current settings for each specified context in the format. See
+CGEQREQ.
[+CGEQNEG: <cid>,<Traffic class>,<Maximum bitrate UL>,<Maximum bitrate
DL>,<Guaranteed bitrate UL>,<Guaranteed bitrate DL>,<Delivery
order>,<Maximum SDU size>,<SDU error ratio>,<Residual bit error
ratio>,<Delivery of erroneous SDUs>,<Transfer delay>,<Traffic
handling><CR><LF>]
[+CGEQNEG:…]
Notes
„
Reference: 3GPP TS 27.007.
PDP Context +CGACT
Execute command activates or deactivates the specified PDP contexts.
Read command returns the current activation state for all the defined PDP contexts in the format:
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>[…]]
Test command reports information on the supported PDP context activation states parameters in the format:
+CGACT: (0,1)