Synaccess Networks NP-0801DTM - Manual (Page 300)

GPS AT COMMANDS SET
HSPA+ AT Commands Reference Guide 300
Update Terminal Information #LCSTER
Set command updates the terminal information like IMSI, MSISDN or IPv4 address.
Syntax
Command Command type
AT$LCSTER=<id_type>[,<id_value>[,<pref_pos_mode>[,<tls_mode>]]] Set
Parameters and Values
<id_type> A number.
0 MSIDSN.
1 IMSI.
2 IPv4 address.
3 Invalid.
<id_value> A string, as defined in <id_type>.
<pref_pos_mode> Preferred position mode.
0 Default position mode.
1 None preferred position mode.
<tls_mode> Indicates if TLS mode is used by the SET.
0 Non‐TLS mode.
1 TLS mode. Default: 1.
Notes
„
If <id_type> is MSISDN or IPv4 address then <id_value> is entered.
Enable/Disable Unsolicited Response $LICLS
Set command enables or disables unsolicited $LICLS response.
Read command returns the current value of parameter <mode>.
Test command returns the range of values for parameter <mode>.
Syntax
Command Command type
AT$LICLS =<mode> Set
AT$LICLS? Read
AT$LICLS=? Test