Synaccess Networks NP-0801DTM - Manual (Page 214)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 214
#SS: 2,4,91.80.90.162,1000
#SS: 3,0
#SS: 4,0
#SS: 5,3,91.80.73.70,61120,88.37.127.146,10509
#SS: 6,0
OK
Socket 1: opened from local IP 91.80.90.162/local port 61119 to remote IP 88.37.127.146/remote port 10510 is
suspended with pending data
Socket 2: listening on local IP 91.80.90.162/local port 1000
Socket 5: opened from local IP 91.80.73.70/local port 61120 to remote IP 88.37.127.146/remote port 10509 is
suspended with pending data
AT#SS=2
#SS: 2,4,91.80.90.162,1000
OK
Information only about socket number 2
Socket Info #SI
Execute command gets information about socket data traffic.
Test command reports the range for parameter <connId>.
Syntax
Command Command type
AT#SI[=<connId>] Execute
AT#SI=?s Test
Parameters and Values
<connId> Socket connection identifier.
1‐6
The response format is:
#SI: <connId>,<sent>,<received>,<buff_in>,<ack_waiting>
where:
<connId> Socket connection identifier.
<sent> Total amount (in bytes) of sent data since the last time the socket connection
identified by <connId> is opened.
<received> Total amount (in bytes) of received data since the last time the socket connection
identified by <connId> is opened.
<buff_in> Total amount (in bytes) of data just arrived through the socket connection
identified by <connId> and currently buffered, not yet read.
<ack_waiting> Total amount (in bytes) of sent and not yet acknowledged data since the last time