Synaccess Networks NP-0801DTM - Manual (Page 197)

CUSTOM AT COMMANDS
197 HSPA+ AT Commands Reference Guide
AT#SMSATRUN=<mod> Set
AT#SMSATRUN? Read
AT#SMSATRUN =? Test
Parameters and Values
<mod>
0 Service disabled. Default: 0.
1 Service enabled.
Notes
„
When the service is active on a specific AT instance, that instance cannot be used for any other scope, except for
OTA service that has the highest priority. For more information, see AT#SMSATRUNCFG.
For example in the multiplexer request to establish the instance, the request is rejected.
„
The current settings are stored in non‐volatile memory.
„
By default the SMS AT RUN service is disabled. You can enable it with the command AT#SMSATRUN or by
receiving a special SMS sent from a Telit server.
Set SMS Run AT Service Parameters #SMSATRUNCFG
Set command configures the SMS AT RUN service.
Read command returns the current settings of parameters in the format:
#SMSATRUNCFG:<instance>,<urcmod>,<timeout>
Test command returns the supported values for the parameters
Syntax
Command Command type
AT#SMSATRUNCFG=<instance>[,<urcmod>[,<timeout>]] Set
AT#SMSATRUNCFG? Read
AT#SMSATRUNCFG=? Test
Parameters and Values
<instance> AT instance used by the service to run the AT command. Range 2 – 3. Default: 3.
<urcmod>
0 Disable unsolicited message.
1 Enable an unsolicited message when an AT command is requested via SMS.
Default: 1.
When unsolicited is enabled, the AT command requested via SMS is indicated to
TE with unsolicited result code:
#SMSATRUN: <Text>
For example:
#SMSATRUN: AT+CGMR;+CGSN;+GSN;+CCLK
Unsolicited is dumped on the instance that requested the service activation.
<timeout> Defines in minutes the maximum time for a command execution. If timeout
expires the module is rebooted.