Synaccess Networks NP-0801DTM - Manual (Page 113)

3GPP TS 27.007 AT COMMANDS
113 HSPA+ AT Commands Reference Guide
200…950
1000…4000
<Traffic handling priority> Traffic handling priority
1…3
<Source Statistics
Descriptor> Characteristics of the source of the submitted SDUs for a PDP context.
Provide this parameter if the <Traffic class> is specified as conversational or
streaming.
0 Characteristics of SDUs is unknown. Default: 0.
1 Characteristics of SDUs corresponds to a speech source.
<Signalling Indication> Signalling content of submitted SDUs for a PDP context. Provide this
parameter if the <Traffic class> is specified as interactive.
0 PDP context is not optimized for signaling. Default: 0.
1 PDP context is optimized for signaling.
Note: A special form of the Set command, +CGEQMIN=<cid> causes the
requested profile for context number <cid> to become undefined.
Note: The current settings are stored in non‐volatile memory.
Note: Set command can modify the 2G QoS according to 3GPP 23.107. See
+CGQMIN.
PDP Context Activate or Deactivate +CGACT
Execute command activates or deactivates the specified PDP contexts.
Read command returns the current activation state for all the defined PDP contexts in the format:
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>[…]]
Test command reports information on the supported PDP context activation states parameters in the format:
+CGACT: (0,1)
Syntax
Command Command type
AT+CGACT=[<state>[,<cid>[,<cid>[,…]]]]
AT+CGACT? Read
AT+CGACT=?
Parameters and Values
<state> Indicates the state of PDP context activation.
0 Deactivated
1 Activated
<cid> Numeric parameter which specifies a particular PDP context definition. See
+CGDCONT.
Note: Only three <cid>s can be activated at the same time.
Note: If no <cid>s are specified, the command’s activation form activates the first
three defined contexts. The deactivation form deactivates all active contexts.
Notes
„
Reference: 3GPP TS 27.007.