Synaccess Networks NP-0801DTM - Manual (Page 165)

CUSTOM AT COMMANDS
165 HSPA+ AT Commands Reference Guide
UMTS network
0 Active set.
1 Candidate set.
2 Synchronized neighbor set.
3 Asynchronized neighbor set.
4‐7 Not available.
Notes
„
The timing advance value is meaningful only during calls or GPRS transfers active.
„
The serving cell is the current serving cell or the last available serving cell, if the module loses coverage.
Examples
Set command selects the cell 0
at#moni=0
OK
Execute command reports GSM‐related information for cell 0
at#moni
#MONI: I WIND BSIC:70 RxQual:0 LAC:55FA Id:1D23 ARFCN:736 PWR:-83dbm TA:1
OK
Set command selects the special request to obtain GSM‐related information from the whole set of seven cells in
the neighbor list of the serving cell
at#moni=7
OK
Execute command reports the requested information in table‐like format
at#moni
#MONI: Cell BSIC LAC CellId ARFCN Power C1 C2 TA RxQual PLMN
#MONI: S 70 55FA 1D23 736 -83dbm 19 33 1 0 I WIND
#MONI: N1 75 55FA 1297 983 -78dbm 26 20
#MONI: N2 72 55FA 1289 976 -82dbm 22 16
#MONI: N3 70 55FA 1D15 749 -92dbm 10 18
#MONI: N4 72 55FA 1D0D 751 -92dbm 10 18
#MONI: N5 75 55FA 1296 978 -95dbm 9 3
#MONI: N6 70 55FA 1D77 756 -99dbm 3 11
OK