Synaccess Networks NP-0801DTM - Manual (Page 308)

AUDIO COMMANDS
HSPA+ AT Commands Reference Guide 308
#STM: <mode>
Test command reports supported range of values for <mode>.
Syntax
Command Command type
AT#STM=[<mode>] Set
AT#STM? Read
AT#STM=? Test
Parameters and Values
<mode> Signaling tones status.
0 Signaling tones disabled.
1 Signaling tones enabled.
2 All tones disabled.
Notes
„
AT#STM=0 has the same effect as AT+CALM=2.
„
AT#STM=1 has the same effect as AT+CALM=0.
Tone Playback #TONE
Execute command allows the reproduction of DTMF tones, standard free tone, standard busy tone and a set of
user defined tones for a certain time.
Test command returns the supported range of values for <tone> and <duration>.
Syntax
Command Command type
AT#TONE=<tone>[,<duration>] Execute
AT#TONE=? Test
Parameters and Values
<tone> ASCII characters. Range: ((0‐9),#,*,(A‐D),(G‐L),Y,Z).
(0‐9), #,*,(A‐D) DTMF tone.
G‐L User‐defined tones.
Y Free tone.
Z Busy tone.
<duration> Duration of current tone in 1/10 of second.
1‐300 Tenth of seconds Default: 30.
Notes
„
For more information about setting user‐defined tones see AT#UDTSET.
Extended Tone Generation #TONEEXT
Execute command allows the reproduction of DTMF tones, standard free tone, standard busy tone and a set of
user defined tones for a infinite time, or stop the running tone.