Synaccess Networks NP-0801DTM - Manual (Page 237)

CUSTOM AT COMMANDS
237 HSPA+ AT Commands Reference Guide
Context Activation and Configuration Extended #SGACTCFGEXT
Execute command enables new features related to context activation.
Read command reports the state of all the five contexts, in the format:
#SGACTCFGEXT: <cid1>,<abortAttemptEnable1>,0,0,0<CR><LF>
…
#SGACTCFGEXT: <cid5>,<abortAttemptEnable5>,0,0,0<CR><LF>
where:
<cidn> PDP context identifier.
<abortAttemptEnable n> See <abortAttemptEnable> in the Parameters and Values section
that follows.
Test command reports supported range of values for all parameters.
Syntax
Command Command type
AT#SGACTCFGEXT=cid>,<abortAttemptEnable>[,<unused>
[,<unused>[,<unused>]]] Execute
AT#SGACTCFGEXT? Read
AT#SGACTCFGEXT=? Test
Parameters and Values
<cid> PDP context identifier. See +CGDCONT.
1‐5 Numeric parameter that specifies a PDP context definition.
<abortAttemptEnable>
0 Old behavior. Abort not possible while attempting context activation.
1 Abort during context activation attempt is possible by sending a byte on the
serial port.
It takes effect on successive GPRS context activation attempt through
#SGACT command in the following manner.
While waiting for AT#SGACT=<cid>,1 response (up to 150 s) is possible to
abort attempt by sending a byte and get back AT interface control (NO
CARRIER indication).
Notes
„
Values are automatically saved in non‐volatile memory.
„
If you receive delayed CTXT ACTIVATION ACCEPT after abort, network is automatically informed of the aborted
attempt through relative protocol messages (SM STATUS) and also closes on its side.
Otherwise, if no ACCEPT is received after abort, network is informed later of PDP state through other protocol
messages; for example, routing area update.
„
Reference: V.25ter