Synaccess Networks NP-0801DTM - Manual (Page 56)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 56
Parameters and Values
<mode> Defines whether the operator selection is done automatically or it is forced by
this command to operator <oper>. The operator <oper> is given in format
<format>.
0 Automatic choice. The parameter <oper> is ignored. Default: 0.
1 Manual choice. <oper> field is present.
2 De‐register from GSM network; the module is kept unregistered until a +COPS
with <mode>=0, 1 or 4 is issued.
3 Set only <format> parameter. The parameter <oper> is ignored.
4 <manual/automatic (<oper> field is present); if manual selection fails, automatic
mode (<mode>=0) is entered
<format>
0 Alphanumeric long form. Maximum length is 16 digits. the RTC (issuing +CCLK)
2 Numeric 5 or 6 digits [country code (3) + network code (2 or 3)]
<oper> Network operator in format defined by <format> parameter.
<AcT> Access technology selected.
0 GSM.
2 UTRAN.
Notes
„
<mode> parameter setting is stored in non‐volatile memory and available at next reboot, if it is not 3—that is,
set only <format> parameter.
„
If <mode>=1 or 4, the selected network is stored in non‐volatile memory too and is available at next reboot. This
occurs even with a new SIM inserted.
„
<format> parameter setting is never stored in non‐volatile memory.
„
Reference: 3GPP TS 27.007
Select Wireless Network +WS46
Set command selects the cellular network (Wireless Data Service, WDS) to operate with the TA (WDS‐Side Stack
Selection).
Read command reports the currently selected cellular network, in the format:
+ WS46: <n>
Test command reports the range for the parameter <n>.
Syntax
Command Command type
AT+WS46=[<n>] Set
AT+WS46? Read
AT+WS46=? Test