Synaccess Networks NP-0801DTM - Manual (Page 69)

3GPP TS 27.007 AT COMMANDS
69 HSPA+ AT Commands Reference Guide
<idn> Call identification number.
<dir> Call direction.
0 Mobile originated call.
1 Mobile terminated call.
<stat> State of the call.
0 Active.
1 Held.
2 Dialing (MO call).
3 Alerting (MO call).
4 Incoming (MT call).
5 Waiting (MT call).
<mode> Call type.
0 Voice.
1 Data.
9 Unknown.
<mpty> Multiparty call flag.
0 Call is not one of multiparty (conference) call parties.
1 Call is one of multiparty (conference) call parties.
<number> String type, phone number in format specified by <type>.
<type> Type of phone number octet in integer format.
129 National numbering scheme.
145 International numbering scheme. Contains the character "+".
<alpha> String type; alphanumeric representation of <number> corresponding to the
entry found in phonebook. Character set used is the one selected with +CSCS.
Note: If no call is active then only OK message is sent. This command is useful in
conjunction with command +CHLD to know the various call status for call holding.
Test command returns the OK result code.
Syntax
Command Command type
AT+CLCC Execute
AT+CLCC=? Test
Notes
„
Reference: 3GPP TS 27.007.
SS Notification +CSSN
This command controls supplementary service related network initiated notifications.
Set command enables or disables the presentation of notification result codes from TA to TE.
Read command reports the current value of the parameters.
Test command reports the supported range of values for <n>, <m>.