Synaccess Networks NP-0801DTM - Manual (Page 190)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 190
Read command reports the duration in ms of the pulse generated, in the format:
#PSMRI: <x>
Test command reports the supported range of values for parameter <x>
Syntax
Command Command type
AT#PSMRI= <x> Set
#PSMRI? Read
#PSMRI =? Test
Parameters and Values
<x> RI enabling.
0 Disables RI pin response for URC message. Default: 0.
50‐1150 Enables RI pin response for URC messages.
Notes
„
The behavior for #PSMRI is invoked, only when modem is in sleep mode (AT+CFUN=7)
„
The value set by command is stored in the profile extended section and does not depend on the specific AT
instance.
„
When RING signal from incoming call/SMS/socket listen is enabled, the behavior for #PSMRI is ignored.
Report Concatenated SMS Indexes #CMGLCONCINDEX
The command reports a line for each concatenated SMS containing:
#CMGLCONCINDEX: N,i,j,k,...
where
N The number of segments that form the whole concatenated SMS.
I,j,k The SMS indexes of each SMS segment , 0 if segment has not been received.
If no concatenated SMS is present on the SIM, only OK result code is returned.
Test command returns OK result code.
Syntax
Command Command type
AT#CMGLCONCINDEX
AT#CMGLCONCINDEX=? Test
Examples
at#cmglconcindex
#CMGLCONCINDEX: 3,0,2,3
#CMGLCONCINDEX: 5,4,5,6,0,8
OK