Notes, Gprs network registration status +cgreg, Syntax – Synaccess Networks NP-0801DTM User Manual
Page 102: Parameters and values, Unsolicited result codes
3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide
102
The mobile equipment has forced a change of MS class. The highest available class is reported, see +CGCLASS.
Notes
Reference: 3GPP TS 27.007.
GPRS Network Registration Status +CGREG
Set command controls the presentation of an unsolicited result code +CGREG: For more information about the
result codes see the section Unsolicited Result Codes.
Read command returns the status of result code presentation mode <n> and the integer <stat> which shows
whether the network has currently indicated the registration of the terminal in the format:
+CGREG: <n>,<stat>[,<lac>,<ci>[,
<AcT>
,<rac>]]
Note: <lac>, <Ci>, <AcT> and <rac> are reported only if <mode>=2 and the mobile is registered on some network
cell.
Test command returns supported values for parameter <n>.
Syntax
Command
Command type
AT+CGREG=[<n>]
AT+CGREG?
Read
AT+CGREG=?
Parameters and Values
<n>
Result code presentation mode.
0
Disable network registration unsolicited result code.
1
Enable network registration unsolicited result code.
Unsolicited Result Codes
If there is a change in the terminal GPRS network registration status, it is issued the unsolicited result code:
+CGREG: <stat>
where:
<stat>
Registration status.
0
Not registered, terminal is not currently search for a new operator to register with.
1
Registered, home network.
2
Not registered. Terminal is currently searching for a new operator to register with.
3
Registration denied.
4
Unknown.
5
Registered, roaming.
2 ‐ enable network registration and location information unsolicited result code; if there is a change of the
network cell, it is issued the unsolicited result code:
+CGREG: <stat>[,<lac>,<ci>[,<AcT>,<rac>]]
where: