Synaccess Networks NP-0801DTM - Manual (Page 57)

3GPP TS 27.007 AT COMMANDS
57 HSPA+ AT Commands Reference Guide
Parameters and Values
<n> Integer type. The WDS‐Side Stack that the TA uses.
12 GSM digital cellular.
22 UTRAN only.
25 3GPP Systems (both GERAN and UTRAN). Default: 25.
Notes
„
Value of <n> is stored in non‐volatile memory and is available after reboot.
„
Reference: 3GPP TS 27.007.
Facility Lock/Unlock +CLCK
Execute command locks or unlocks a ME on a network facility.
Test command reports all the facilities supported by the device.
Syntax
Command Command type
AT+CLCK=<fac>, <mode> [,<passwd>[,<class>]] Execute
AT+CLCK=? Test
Parameters and Values
<fac> Facility.
“PS” PH‐SIM (lock Phone to SIM card) MT asks password when other than current SIM
card inserted; MT may remember certain amount of previously used cards thus
not requiring password when they are inserted.
“PF” Lock Phone to the first inserted SIM card (MT asks password when other than the
first SIM card is inserted)
“SC” SIM (PIN request) (device asks SIM password at power‐up and when this lock
command issued)
“AO” BAOC (Barr All Outgoing Calls)
“OI” BOIC (Barr Outgoing International Calls)
“OX” BOIC‐exHC (Barr Outgoing International Calls except to Home Country)
“AI” BAIC (Barr All Incoming Calls)
“IR” BIC‐roam (Barr Incoming Calls when Roaming outside the home country)
“AB” All Barring services (applicable only for <mode> =0)
“AG” All out going barring services (applicable only for <mode> =0) (not yet supported)
“AC” All incoming barring services (applicable only for <mode> =0)
“FD” SIM fixed dialing memory feature (if PIN2 authentication has not been done
during the current session, PIN2 is required as <passwd>)
“PN” Network personalization
“PU” Network subset personalization
“PP” Service provider personalization
"PC" Corporate personalization
“MC” Multi country lock
<class> Sum of integers each representing a class of information. Default: 7.