Synaccess Networks NP-0801DTM - Manual (Page 35)

HAYES COMPLIANT AT COMMANDS
35 HSPA+ AT Commands Reference Guide
Ring (RI) Control \R
Set command controls the RING output pin behavior.
Syntax
Command Command type
AT\R[<n>] Set
Parameters and Values
<n>
0 RING on during ringing and further connection.
1 RING on during ringing. Default: 1.
2 RING follows the ring signal.
Notes
„
To check the ring option status use the &V command.
„
If parameter is omitted, the command has the same behavior as AT\R0.
Fixed DTE Interface Rate +IPR
Set command specifies the DTE speed at which the device accepts commands during command mode operations;
it may be used to fix the DTE‐DCE interface speed.
Read command returns the current value of +IPR parameter.
Test command returns the list of fixed‐only <rate> values in the format:
+IPR: (list of fixed‐only <rate> values)
Syntax
Command Command type
AT+IPR=<rate> Set
AT+IPR? Read
AT+IPR=? Test