Synaccess Networks NP-0801DTM - Manual (Page 55)

3GPP TS 27.007 AT COMMANDS
55 HSPA+ AT Commands Reference Guide
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,1
OK
The MODULE is registered.
at+creg?
+CREG: 0,1
OK
Operator Selection +COPS
Set command tries to select and register the GSM network operator.
Read command returns current value of <mode>,<format>,<oper> and <AcT> in format <format>. If no operator is
selected, <format>, <oper> and <AcT> are omitted.
+COPS: <mode>[, <format>, <oper>,< AcT>]
Test command returns a list of quadruplets, each representing an operator present in the network.
The quadruplets in the list are separated by commas:
+COPS: [list of supported (<stat> ,<oper (in <format>=0)>,,
<oper (in <format>=2)>,< AcT>)s][,,(list of supported <mode>s),
(list of supported<format>s)]
where
<stat> Operator availability.
0 Unknown.
1 Available.
2 Current.
3 Forbidden.
<AcT> Access technology selected.
0 GSM.
2 UTRAN.
Note: Because this command requires network scan, it may take a few second to return the output.
Syntax
Command Command type
AT+COPS=[<mode>[,<format>[,<oper>[,< AcT>]]]] Set
AT+COPS? Read
AT+COPS=? Test