Lenze ECSCSxxx - Manual (Page 103)

Commissioning
Setting of the feedback system for position and speed control
6
l
103 EDBCSXS064 EN 4.0
6.8 Setting of the feedback system for position and speed control
The following feedback systems can be selected for position and speed control:
ƒ Resolver (
¶ 104)
ƒ TTL incremental encoder/SinCos encoder without serial communication (
¶ 106)
– as position and speed encoder ( ¶ 106)
– as position encoder and resolver as speed encoder (
¶ 109)
ƒ Absolute value encoder (Hiperface®, single−turn/multi−turn)
– as position and speed encoder (
¶ 113)
– as position encoder and resolver as speed encoder (
¶ 117)
The GDC includes the parameters or codes to be set in the parameter menu under
Short setup
W Feedback system:
ECSXA304
Fig. 6−6 GDC view: Short setup of the feedback system
)
Note!
If the Lenze setting has been loaded via C0002, the feedback system must be
reset.