Lenze ECSCSxxx - Manual (Page 477)

Index 14
l
477 EDBCSXS064 EN 4.0
J
Jitter, 179 , 180
K
Keypad XT EMZ9371BC
− changing and saving parameters, 167
− connecting the keypad, 163
− display elements, 164
− fault analysis, 232
− function keys, 166
L
LECOM, status word (C0150/C0155), 235
LEDs, 232
Legal regulations, 18
Liability, 18
Loading the Lenze setting, 97
Low−voltage supply, 13
M
Main setpoint
− Influencing the ramp function generator, 329
− influencing the ramp function generator, 352
Mains fuses, 466
Malfunction of drive, 237
Manufacturer, 18
Master frequency input (DFIN), 301
− configuring the input signal, 303
Master frequency input signal, configuring, 303
Master frequency output (DFOUT), 304
Master frequency output signal, configuring, 306
Max. system speed, monitoring functions, 223
Maximum speed
− Operating mode "Speed control", 333
− operating mode "Torque control", 355
MCTRL_MotorControl (motor control), monitoring, absolute
value encoder initialisation, 220
Mechanical installation, 39
− cold−plate technique (ECSCx...), 46
− important notes, 39
− push−through technique (ECSDx...), 42
− with fixing rails (ECSEx...), 41
Message, 193
Monitoring
− absolute value encoder initialisation, 220
− CAN interface, timeout with activated remote
parameterisation, 200
− current load of the motor, I2 x t monitoring, 23 , 210
− FAIL−QSP, 193
− message, 193
− Monitoring times for process data input objects, 198
− voltage supply of control electronics, 217
− warning, 193
Monitoring functions, 192
− bus off, 199
− configuring, 198
− current load of controller, I x t monitoring, 207
− DC−bus voltage, 214
− earth fault, 201
− heatsink temperature, 204
− max. system speed, 223
− motor phase failure, 217
− Motor temperature, 23
− motor temperature, 202
− motor temperature sensor, 219
− Overview, 194
− Resolver cable, 218
− rotor position adjustment, 224
− short circuit, 201
− sin/cos signal, 221
− speed system deviation, 222
− temperature inside the controller, 205
− thermal sensors, 206
Monitoring of internal device temperature (OH1, OH5),
205
Monitoring of the synchronisation, 181
Monitoring times for process data input objects, 198