Lenze ECSCSxxx - Manual (Page 379)

Appendix
Code table
13
l
379 EDBCSXS064 EN 4.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0190 NSET ARIT 0 Linking of speed setpoint (NSet)
and additional setpoint (NAdd) ^ 331
0 OUT = NAdd Additional setpoint is not
considered.
1 NSet + NAdd Additional setpoint is added to
speed setpoint.
2 NSET−NADD Additional setpoint is subtracted
from speed setpoint.
3 NSet x NAdd Additional setpoint is multiplied
by speed setpoint.
4 NSet / NAdd Speed setpoint is divided by
additional setpoint.
5 NSet / (100 − NAdd) Speed setpoint is divided by (100
− additional setpoint).
C0195 BRK T act 99.9 Closing time of the motor
holding brake ^ 340
^ 360
^ 102
0.0 {0.1 sec} 99.9 During the time set the drive
continues to generate a torque.
After the set time is expired, the
status "mechanical brake closed"
is reached.
C0196 BRK T rel 0.0 Opening time of the motor
holding brake ^ 340
^ 360
^ 102
0.0 {0.1 sec} 60.0 During the time set the drive can
generate the torque set under
C0244 against the holding brake.
After the set time is expired, the
status "mechanical brake
opened" is reached.
C0199 BuildNumber Software identification
Only display
C0200 S/W Id Software identification
Only display
C0201 S/W date Software release date
Read only
C0202 Service code
Only display
1 Product code 1
... ...
4 Product code 4
C0203 Komm.−No. x / xxxx / xxxxx Commission number
Only display
C0204 Serial−No. Serial number
Read only
C0205 PLC Target ID Identification key
Only display
C0206 Product. date Production date
Only display
C0207 DL info 1 Download info 1
Only display
C0208 DL info 2 Download info 2
Only display
C0209 DL info 3 Download info 3
Only display