Lenze ECSCSxxx - Manual (Page 400)

Appendix
Code table
13
l
400 EDBCSXS064 EN 4.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C2120 AIF: Control 0 AIF−CAN: control word
0 {1} 255 Binary interpretation reflects bit
states
0 No command Note: The MSB (bit 7) of the
control word automatically
changes its state with every
access to the code. Observe this
when interpreting the data!
1 Read XCAN codes + reinitialisation
2 Read XCAN code
10 Read XCAN C2356/1 ... 4
11 Read XCAN C2357
12 Read XCAN C2375
13 Read XCAN C2376 ... C2378
14 Read XCAN C2382
255 Not assigned
C2121 AIF:State AIF status
More detailed information can
be found in the documentation
of the plugged−in fieldbus
module.
Read only
1 {1} 255 Binary interpretation reflects bit
states.
Bit 0 XCAN1_IN monitoring time
Bit 1 XCAN2_IN monitoring time
Bit2 XCAN3_IN monitoring time
Bit3 XCAN bus off
Bit4 XCAN operational
Bit5 XCAN pre−operational
Bit 6 XCAN warning
Bit 7 Assigned internally
C2130 FileNameAdd
Da
Symbolic data name Information on the additional
data that have been transmitted
together with the application
program.
Only display
C2131 Type AddData Specification identification of the data
C2132 VersionAddDa
ta
Data version
C2133 TimeStamp Time stamp of the data
C2350 XCAN address 1 Node address XCAN
(AIF interface X1)
1 {1} 63
C2351 XCAN baud
rate
0 Baud rate XCAN
(AIF interface X1)
0 500 kbps
1 250 kbit/sec
2 125 kbits/s
3 50 kbps
4 1000 kbit/s
C2352 XCAN mst 0 Establish XCAN master
operation.
(AIF interface X1)
0 Slave
1 Master