1 terminology used, Terminology used, Preface and general information – Lenze ECSCSxxx User Manual
Page 13
Preface and general information
About these Operating Instructions
Terminology used
l
13
EDBCSXS064 EN 4.0
1.1.1
Terminology used
Term
In the following text used for
Power supply module
ECSxE... power supply module
ECSxE...
Capacitor module
ECSxK... capacitor module
ECSxK...
Axis module
Controller
Standard device
Axis module of the ECS series
l
ECSxS... − "Speed and Torque"
l
ECSxP... − "Posi and Shaft"
l
ECSxM... − "Motion"
l
ECSxA... − "Application"
ECSxS...
ECSxP...
ECSxM...
ECSxA ...
Drive system
ECS drive system consisting of:
l
ECSxE... power supply module
l
Axis module ECSxS... / ECSxP... / ECSxM... / ECSxA...
l
ECSxK series capacitor module (optional)
l
further Lenze drive components (accessories)
24 V supply
Low−voltage supply
Voltage supply
l
of the control card, voltage range 20 ... 30 V DC (
±0 V)
l
of the "safe torque off" function (formerly "safe standstill"), voltage range
18 ... 30 V DC (
±0 V)
l
of the motor holding brake, voltage range 23 ... 30 V DC (
±0 V)
AIF
Automation InterFace
System bus (CAN)
Lenze standard bus system based on CANopen for
l
communication with a higher−level host system (PLC) or further controllers.
l
parameter setting and diagnostics.
MotionBus (CAN)
The "MotionBus (CAN)" term expresses the functionality of the CAN interface X4 in
case of ECSxS/P/M... axis modules, where communication takes place using a
higher−level host system (PLC) or further controllers exclusively via the X4 interface.
Interface X14 (CAN−AUX) is exclusively used for parameter setting and diagnostics.
DDS
Drive PLC Developer Studio
(Lenze software for PLC programming acc. to IEC 61131)
GDC
Global Drive Control
(Lenze software for parameter setting and diagnostics)
GDO
Global Drive Oscilloscope
(additional diagnostic tool of the GDC)
Cxxxx
Code Cxxxx (e.g. C0351)
Parameters which serve to parameterise or monitor the controller.
Cxxxx/y
Subcode y of code Cxxxx (e. g. C0470/3 = subcode 3 of code C0470)
Xk/y
Terminal y on terminal strip Xk (e.g. X6/B+ = terminal B+ on terminal strip X6)