Lenze ECSCSxxx - Manual (Page 104)

Commissioning
Setting of the feedback system for position and speed control
Resolver as position and speed encoder
6
l
104 EDBCSXS064 EN 4.0
6.8.1 Resolver as position and speed encoder
If a resolver is connected to X7 and used as a position and speed encoder, no settings are
necessary.
Lenze setting:
ƒ Resolver as position encoder: C0490 = 0
ƒ Resolver as speed encoder: C0495 = 0
Code Possible settings IMPORTANT
No. Designation Lenze/
{Appl.} Selection
[C0490] Feedback pos 0 Selection of feedback system for
positioning control ^ 103
0 Resolver at X7 Standard setting
1 TTL encoder at X8 l Sets C0419 = 0 ("Common") if
a different encoder type as
under C0419 is set here.
2 SinCos encoder at X8
3 Absolute value encoder (single−turn) at
X8
4 Absolute value encoder (multi−turn) at
X8
[C0495] Feedback n 0 Selection of feedback system for
speed control ^ 103
0 Resolver at X7 Standard setting
1 TTL encoder at X8 l Sets C0419 = 0 ("Common") if
a different encoder type as
under C0419 is set here.
2 SinCos encoder at X8
3 Absolute value encoder (single−turn) at
X8
4 Absolute value encoder (multi−turn) at
X8
C0058 Rotor diff −90.0 Rotor displacement angle (offset
angle)
Input in case of Lenze motor with
l resolver: −90°
l hiperface absolute value
encoder: 0°
Code value is adapted by the
rotor position adjustment
function (C0095).
Only relevant for the operation
of synchronous motors.
^ 151
−180.0 {0.1 _} 179.9
C0060 Rotor pos Current rotor position; value is
derived from position encoder.
Therefore, it is only valid as rotor
position if the position encoder
settings under C0490 are
identical with the settings of the
speed encoder on the motor
shaft under C0495.
Read only
^ 148
0 {1 inc} 2047 Display with reduced resolution:
1 revolution = 2048 increments
[C0080] Res pole no. 1 Number of pole pairs of resolver
1 {1} 10