Lenze ECSCSxxx - Manual (Page 378)

Appendix
Code table
13
l
378 EDBCSXS064 EN 4.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0178 Op timer Running time meter
Read only
0 {1 sec} 4294967295 Time when the controller was
enabled
C0179 Mains timer Power−on time meter
Only display
0 {1 sec} 4294967295 Time when the mains was
switched on
C0182 Ti S−shaped 20.00 Form of the S−curve for the
l speed setpoint (for "speed
control")
l torque setpoint (for "torque
control")
of the ramp function generator
(C0134 = 1)
^ 330
0.01 {0.01 s} 50.00 The higher the value, the bigger
the S−rounding.
C0183 Diagnostics Drive diagnostics
Read only
l Indicates fault or status
information
l If several fault or status
information are to be shown
at the same time, the
information with the smallest
number is displayed
0 OK No fault
101 Initialisation phase
102 TRIP/trouble
103 Emergency stop activated
104 IMP message
105 Power off
111 Operation inhibit C0135
112 Operation inhibit AIF
113 Operation inhibit CAN
121 Controller inhibit via X6/SI1
122 Internal controller inhibit 1
123 Internal controller inhibit 2
124 Controller inhibit via STOP key of the
keypad
125 Controller inhibit via AIF
126 Controller inhibit via CAN
131 Fail QSP
141 Restart protection
142 Pulse inhibit High resistance power outputs
151 Quick stop (QSP) via terminal
152 Quick stop (QSP) via STOP key of the
keypad
153 Quick stop (QSP) via AIF
154 Quick stop (QSP) via CAN
160 PLC Stop PLC must be started.
250 Warning