Figure 3.4.4.47 example program 1, Figure 3.4.4.48 example program 2 – Yaskawa YASNAC PC NC Programming Manual User Manual
Page 118
Advertising
3 - 68
YASNAC PCNC Programming Manual
Chapter 3: Movement Control Commands
(a) Type A: pm4013 D4 = 1 Generation of alarm
The following programs give examples in which the function determines that interference
(overcuts) will occur due to considerable differences between the programmed paths and
the tool paths generated after offset.
•
Example program 1
FIGURE 3.4.4.47 Example Program 1
•
Example program 2
Note:
Since the cutting tool cuts into the workpiece excessively at the end point
ó of block N1, alarm
“0187” occurs.
The operation stops when the cutting tool reaches the end point of block N0.
FIGURE 3.4.4.48 Example Program 2
Advertising