Yaskawa YASNAC PC NC Programming Manual User Manual
Page 22
Advertising
1 - 15
YASNAC PCNC Programming Manual
Chapter 1: Programming Basics
•
In the simultaneous 3-axis control linear interpolation, an F command indicates the
tangential feedrate.
Example of Programming
Fig. 1.2.2.3
F Command in Simultaneous 3-axis Control Linear Interpolation
•
In the simultaneous 4-axis control* linear interpolation, an F command indicates the
tangential feedrate.
•
In the simultaneous 5-axis control* linear interpolation, an F command indicates the
tangential feedrate.
Advertising