Yaskawa YASNAC PC NC Programming Manual - Manual (Page 316)

Appendix 1 - 4
Appendix Table 1.1 G Code Table (cont’d)
Note1: The NC establishes the G code modes, identified by #l, when the power turned ON or when the NC is reset.
2. The NC establishes the G code modes, identified by #2, when the power is turned ON.
3: If both #1 and #2 are indicated in the same G code group, the G codes which should be valid when the
power is turned ON can be selected by the setting for the appropriate parameters.
G Code Group Function Refer to
G90 #2
03
Absolute programming
G91 Incremental programming
G92 #2 * Coordinate system setting
G93
05
Solid tap mode
G94 #1 Feed per minute mode, solid tap mode cancel
G98 #2
10
Canned cycle, initial level return
G99 Canned cycle, R-point level return
G106
*
Automatic comer override
G107 Comer cutting feedrate designation
G108 Corner cutting feedrate designation cancel
G174
09
Deep hole solid tap
G181 Canned cycle (2-step drilling) 4.1.1
G182 Canned cycle (2-step spot facing)
G184 Deep hole solid tap cancel
G185 Canned cycle (2-step boring)
G186 Canned cycle (2-step boring)
G187 Canned cycle (2-step boring)
G189 Canned cycle (2-step boring)