Yaskawa YASNAC PC NC Programming Manual - Manual (Page 3)

ii
YASNAC PCNC Programming Manual Introduction
INFORMATION INDICATORS
The following symbols are used in this operating manual to emphasize particular information to the user:
NOTES REGARDING SAFE OPERATION
It is important that the user should read this manual before installing, operating, performing any
maintenance or inspecting the
`6TI68ÃQ8ÃI8ÃAlso, the functions and performance of a NC machine tool
are not determined by the CNC unit itself, therefore thoroughly read and familiarize yourself with the
machine builder’s documentation concerning the safe and most efficient ways to use the machine tool.
Nevertheless, Yasakawa assumes no responsibility for damages resulting from the use of the information
contained within this publication.
POINT
Indicates important information to be remembered, i.e., precautionary alarm
displays to prevent damaging devices.
SUPPLEMENT Indicates supplementary material.
TERMS
Indicates definitions of terminology that has not been explained before.