Yaskawa YASNAC PC NC Programming Manual - Manual (Page 16)

1 - 9
YASNAC PCNC Programming Manual Chapter 1: Programming Basics
Table 1.1.3.6: Maximum Programmable Values for Axis Movement (Sub Sub-
microns)
Note: The values indicated above do not depend on the “least output increment”.
(1) Programmable Range (Input Format)
This model of NC adopts the variable block format which complies with JIS B6313.
Programmable range of individual addresses is indicated in Table 1.1.3.7. The numbers given
in this table indicate the allowable maximum number of digits.
An example of input format is given below.
Input data should be entered without a decimal point. If a decimal point is used, the entered
values is treated in a different manner. Leading zeros and the “+” (plus) sign can be omitted
for all kinds of address data including sequence number. Note that, however, the “-” (minus)
sign cannot be omitted.
Table 1.1.3.7: Input Format (Standard)
Linear Axis *Rotary Axes
Metric Input ±999999.999 mm ±999999.999 deg.
Address
Metric Output Inch Output
B: Basic
O: Option
Metric Input Metric Input Metric Input Metric Input
Program number O5 O5 B
Sequence number N5 N5 B
G function G3 G3 B
Coordinate words
Linear axis a+63 a+54 a+63 a+54 B
Rotary axis b+63 b+63 b+63 b+63 O
Feed per minute (mm/min) F60 F41 F60 F51 B
Feed per minute (mm/min)
1/10 function
F61 F42 F61 F52 B
S function S 5 S5 B
T function
T 2 T2 B
T 4 T4 O