Yaskawa YASNAC PC NC Programming Manual User Manual
Page 195
Advertising
4 - 58
YASNAC PCNC Programming Manual
Chapter 4: Enhanced Level Commands
FIGURE 4.1.5.2 High-speed Feed Interval Designation by R
•
Designation of circle section repetition by L
By specifying “G12 (or G13) I
• • •
D
• • •
L
• • •
F
• • •
;”, circle cutting is executed by
repeating cutting at the circle section by L times.
•
Spiral circle cutting designation by Q and K
By specifying “G12 (or G13) I
• • •
D
• • •
K
• • •
Q
• • •
F
• • •
;”, the cycle to cut a circle
by controlling the spiral cutting tool path shown in Fig. 4.1.5.3 is defined.
FIGURE 4.1.5.3 Spiral Circle Cut Designation by Q and K
Advertising