Yaskawa YASNAC PC NC Programming Manual User Manual
Page 211
Advertising
4 - 74
YASNAC PCNC Programming Manual
Chapter 4: Enhanced Level Commands
(a) Tool radius is not greater than 1/2 of allowance
In this case, override is: not applied independent of the setting for parameters and feed-
rate is clamped at F
0
.
FIGURE 4.2.2.2 Automatic Corner Override – Tool Radius £ Allowance/2
(b) Tool radius is greater than allowance
FIGURE 4.2.2.3 Automatic Corner Override – Tool Radius > l/J (Allowance)
Advertising