Yaskawa YASNAC PC NC Programming Manual User Manual
Page 299
Advertising
4 - 162
YASNAC PCNC Programming Manual
Chapter 4: Enhanced Level Commands
•
By specifying “GOTO <sequence number>”, it is possible to jump from the DO to
END loop to a block outside the loop. However, jump into the DO to END loop by
using “GOTO <sequence number>” is not possible.
Note;
°: Correct, ×: Incorrect
For the execution of an operation instruction, operation stops or does not stop in the single
block stop mode if the single block input (SKB) is ON according to the setting for parameter
pm0007 D1.
pm0007 D1 = 0
Does not stop in the signal
-
block mode
pm0007 D1 = 1
Stops in the single
-
block mode.
Advertising