Adept AdeptSight User Guide - Manual (Page 350)

Configuring Caliper Properties
Found Edges and Caliper
If the display in the Pair Settings window is blank, or the edges are not properly placed, close
the window and verify the following:
l The tool was executed after positioning the tool.
l
The tool was executed at least once before opening the Pair Settings window.
l
The Location parameters are correct.
l
The Y-axis of the tool is parallel to the edges you want to detect.
Constraints are set with the Edge Pair Collection Editor window. From the Object editor win-
dow, select
Configuration > Properties >Pairs > :
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 350