Adept AdeptSight User Guide - Manual (Page 61)

Setting the End-effector Signal Values
Green indicates an enabled signal. Black indicates a disabled signal. Yellow in a text
field indicates an invalid value.
NOTE: These signals need to be set for the Belt Calibration Wizard to work, since
you will need to be able to move the belt with them.
l
Select existing or new camera
The wizard will let you add a new camera at this point if you choose to.
l Camera properties
Edit these, if needed. Refer to Camera Properties on page 223.
Procedure
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 61