Intel PXA26X - Manual (Page 258)

6-68 Intel® PXA26x Processor Family Developer’s Manual
Memory Controller
Figure 6-28. 16-Bit PC Card I/O 16-Bit Access to 8-Bit Device
The interface waits the smallest possible amount of time (x_ASST_WAIT) before it checks the
value of the nPWAIT signal. If the nPWAIT signal is asserted (active low), the interface continues
to wait (for a variable number of wait states) until nPWAIT is deasserted. When the nPWAIT signal
is deasserted, the command continues to be asserted for a fixed amount of time (x_ASST_HOLD).
6.10 Companion Chip Interface
The processor can be connected to a companion chip in two different ways:
• Alternate Bus Master Mode
• Variable Latency I/O (See Section 6.8.5, “Variable Latency I/O (VLIO) Interface Overview” )
The connection methods are illustrated in Figure 6-29 and Figure 6-30 .
Low Byte High Byte
IOx_ASST_HOLD
IOx_ASST_WAIT + wait states
IOx_ASST_HOLD
IOx_ASST_WAIT + wait states
IOx_HOLD
IOx_SET
IOx_HOLD
IOx_SET
0ns 100ns 200ns 300ns
memclk
MA[25:1],nPREG,PSKTSEL
MA[0]
nPCE2
nPCE1
nPIOW,nPIOR
RDnWR
nIOIS16
nPWAIT
read_data
write_data