Intel PXA26X - Manual (Page 446)

12-36 Intel® PXA26x Processor Family Developer’s Manual
Universal Serial Bus Device Controller
12.6.7.2 Transmit Packet Complete (TPC)
The transmit packet complete bit is be set by the UDC when an entire packet is sent to the host.
When this bit is set, the IRx bit in the appropriate UDC status/interrupt register is set if transmit
interrupts are enabled. This bit can be used to validate the other status/error bits in the endpoint(x)
control/status register. The UDCCSx[TPC] bit is cleared by writing a 1 to it. This clears the
interrupt source for the IRx bit in the appropriate UDC status/interrupt register, but the IRx bit must
also be cleared.
The UDC issues NAK handshakes to all IN tokens if this bit is set and the buffer is not triggered by
writing 8 bytes or setting UDCCSx[TSP].
12.6.7.3 Flush Tx FIFO (FTF)
The Flush Tx FIFO bit triggers a reset for the endpoint's transmit FIFO. The Flush Tx FIFO bit is
set when software writes a 1 to it or when the host performs a SET_CONFIGURATION or
SET_INTERFACE. The bit’s read value is zero.
12.6.7.4 Transmit Underrun (TUR)
The transmit underrun bit is be set if the transmit FIFO experiences an underrun. When the UDC
experiences an underrun, NAK handshakes are sent to the host. UDCCSx[TUR] does not generate
an interrupt and is for status only. UDCCSx[TUR] is cleared by writing a 1 to it.
12.6.7.5 Sent STALL (SST)
The sent stall bit is set by the UDC in response to FST successfully forcing a user induced STALL
on the USB bus. This bit is not set if the UDC detects a protocol violation from the host PC when a
STALL handshake is returned automatically. In either event, the core does not intervene and the
UDC clears the STALL status when the host sends a CLEAR_FEATURE command. The endpoint
operation continues normally and does not send another STALL condition, even if the
UDCCSx[SST] bit is set. To allow the software to continue to send the STALL condition on the
USB bus, the UDCCSx[FST] bit must be set again. The core writes a 1 to the sent stall bit to clear
it.
12.6.7.6 Force STALL (FST)
The core can set the force stall bit to force the UDC to issue a STALL handshake to all IN tokens.
STALL handshakes continue to be sent until the core clears this bit by sending a Clear Feature
command. The UDCCSx[SST] bit is set when the STALL state is actually entered, but this may be
delayed if the UDC is active when the UDCCSx[FST] bit is set. The UDCCSx[FST] bit is
automatically cleared when the UDCCSx[SST] bit is set. To ensure that no data is transmitted after
the Clear Feature command is sent and the host resumes IN requests, software must clear the
transmit FIFO by setting the UDCCSx[FTF] bit.
12.6.7.7 Bit 6 Reserved
Bit 6 is reserved for future use.