Intel PXA26X User Manual
Page 365
Intel® PXA26x Processor Family Developer’s Manual
9-27
Inter-Integrated Circuit Bus Interface Unit
Table 9-12. I
2
C Status Register - ISR (Sheet 1 of 2)
Physical Address
4030_1698
I
2
C Status Register
I
2
C
Bit
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
R
eser
ved
BE
D
SA
D
GC
AD
IR
F
ITE
AL
D
SS
D
IB
B
UB
AC
KN
A
K
RW
M
Reset
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
31:11
—
Reserved
10
BED
BUS ERROR DETECTED:
0 – No error detected.
1 – The I
2
C unit sets this bit when it detects one of the following error conditions:
•
As a master transmitter, no ACK is detected on the interface after a byte is sent.
•
As a slave receiver, the I
2
C unit generates a NAK pulse.
NOTE: When an error occurs, I
2
C bus transactions continue. Software must ensure that
misplaced START and STOP conditions do not occur. See
To clear this bit, write a 1 to it.
9
SAD
SLAVE ADDRESS DETECTED:
0 – No slave address detected.
1 – I
2
C unit detected a 7-bit address that matches the general call address or ISAR. An
interrupt is signalled when the SADIE interrupt is set to a 1.
To clear this bit, write a 1 to it.
8
GCAD
GENERAL CALL ADDRESS DETECTED:
0 – No general call address received.
1 – I
2
C unit received a general call address.
7
IRF
IDBR RECEIVE FULL:
0 – The IDBR has not received a new data byte or the I
2
C unit is idle.
1 – The IDBR register received a new data byte from the I
2
C bus. An interrupt is signalled
when the IRFIE is set to a 1.
To clear this bit, write a 1 to it.
6
ITE
IDBR TRANSMIT EMPTY:
0 – The data byte is still being transmitted.
1 – The I
2
C unit has finished transmitting a data byte on the I
2
C bus. An interrupt is
signalled when the ITEIE interrupt is set to 1.
To clear this bit, write a 1 to it.
5
ALD
ARBITRATION LOSS DETECTED:
Used during multi-master operation.
0 – Cleared when arbitration is won or never took place.
1 – Set when the I
2
C unit loses arbitration.
To clear this bit, write a 1 to it.
4
SSD
SLAVE STOP DETECTED:
0 – No STOP detected.
1 – Set when the I
2
C unit detects a STOP while in slave-receive or slave-transmit mode.
To clear this bit, write a 1 to it.
3
IBB
I
2
C BUS BUSY:
0 – I
2
C bus is idle or the I
2
C unit is using the bus (i.e., unit busy).
1 – Set when the I
2
C bus is busy but the I
2
C unit is not involved in the transaction.