Planet Technology IP DSLAM IDL-4801 - Manual (Page 125)

IP DSLAM 125
Output Fields:
Field Description
ifname This specifies the interface index used for the ATM Based Multi pair Bonding
type of interfaces. Valid Value is abond-X. Modification and deletion is not
possible if interface is enabled
GroupId This specifies the group id configured for this interface. This field is configured
statically when the bonded group is provisioned and must not be changed
while the group is in service. These fields may be used by an operator to help
identify mis-configuration or to assist in management or debugging of the link.
MinAggrRateUpstrm Minimum Aggregate Data Rate in bits per second in Upstream direction.
MinAggrRateDnstrm Minimum Aggregate Data Rate in bits per second in Downstream direction.
DiffDelayTolUpstrm The maximum differential delay among member links in a bonding group in
Upstream direction.
DiffDelayTolDnstrm The maximum differential delay among member links in a bonding group in
downstream direction.
AsmProtocol This parameter specifies whether Autonomous Status Messages will be
exchanged between CO and CPE. If it is disabled then the group would be
bonded statically and CO would assume CPE to know all the configuration
parameters like SID format, number of links in the bonded group and the links
participating in bonding. If it is enabled then CO would inform all these
parameters to CPE using Autonomous Status Messages.
SidFormat SID Format: 8 bit or 12 bit SID. Only 8 bit format is being supported
MaxRxBitRateRatio The maximum bit rate ratio among member links in a bonding group in
upstream direction.
LinkHecThreshold HEC Error percentage of the link upstream rate which will act as Threshold for
link to be part of group in Rx direction
CtrlVpi Control Channel VPI: VPI value being used for Sending and Receiving ASM
Messages
CtrlVci Control Channel VCI: VCI value being used for Sending and Receiving ASM
Messages
NoOfLinksUpForGrpUp This field specifies the number of links required to be up for bonding to start
ASM protocol
AsmIrlThreshold IRL Threshold for ASM messages
MaxAtmPortUsRate Maximum ATM port Upstream Rate
Oper Status The actual/current state of the interface. It can be either up or down.