Planet Technology IP DSLAM IDL-4801 - Manual (Page 350)

IDL series User Guide 350
or some value is to be added to existing base offset value to
calculate new base offset value, or the new base offset value is to
be computed using some value in the packet.
Type: Create -- Optional
Modify -- Optional
Default value: ---
shiftcnt <shiftcnt-val> ShiftCount, is the number of times the Value in the
packet is to be shifted before multiplying it with the
gsvClfrProfileNodeMultiplier. This field is valid only if the
gsvClfrProfileNodeAction is SetBase. Value 32 is meant for
internal purpose and Agents should not pass this value to GAG.
GAG may return 32 value to Agent, in which case Agent should
treat it as invalid.
Type: Create -- Optional
Modify -- Optional
Valid values: 0 - 31
Default value: ---
mplr <mplr-val> Multiplier, is used to multiply the value shifted by
ShiftCount. It is used to calculate the new base
offset. This field is valid only if the
gsvClfrProfileNodeAction is SetBase.
Type: Create -- Optional
Modify -- Optional
Valid values: 1 - 32
Default value: ----
Modmask
Act|ValType|Offset|Mask
|Val|None|ValueEnd|Sbt
ype|SBShiftCnt|SBMlpr|
Descrip
This specifies what fields of an exported node are modifiable and
can be modified while the profile is part of a classifier tree.
Type: Create -- Optional
Modify -- Optional
Actval
Drop|Fwd|FwdToCtl|CpT
oCtl|Eq|Gt|Lt|InRange|Te
rCmp|
SetPrio|MatchInList|Acc
Deny|SetBase|Count|
Retagprio |
MatchIngenlist
|GoToNextRule|allow
Action tells what is to be done by a node. 'Drop' means drop the
packet. 'Fwd' means Forward the packet. 'FwdToCtl' means
Forward the packet to control plane. 'CpToCtl' means forward the
packet and also send a copy of the packet to control plane.'Allow'
means give the packet to the next stage. 'GoToNextRule' means
go to the next rule (ruleid) attached on that interface and if no next
rule is attached on that interface then forward the packet. 'Eq'
means check if value specified in the packet is equal to 'Value'. 'Gt'
means check if the value at the location specified in the packet is
greater than 'Value'. 'Lt' means check if the value at the location
specified in the packet is Less than 'Value'. 'InRange' means