Planet Technology IP DSLAM IDL-4801 - Manual (Page 349)

IP DSLAM 349
Default value: FALSE
Ntype
Leaf|Unary|Binary|Ternar
y|Linear|NonLinear
This specifies the type of the Classifier node.
Type: Create -- Optional
maskval <maskval-val> Mask, used to select the individual bits to be matched in a packet.
If gsvClfrProfileNodeAction is SetBase and
gsvClfrProfileNodeSetBaseType is Compute, then this value is
used to specify the mask, which shall be used to identify the
individual bits of the field of the packet used to compute the new
base offset. This field is valid only if the
gsvClfrProfileNodeValType is U8, U16, U32 or U64.
This field is also valid if the g gsvClfrProfileNodeAction is
MatchInGenList.
Type : Create --Optional
Default Value : --
value <value-val> Value, to be matched. For NonLinear node types,
this field is not valid. For Linear node types, this
value is used to specify the start of the range. If
gsvClfrProfileNodeAction is SetBase and
gsvClfrProfileNodeSetBaseType is Compute then
this field is used to specify the value, which is to be
added to base offset to calculate new base offset. If
the gsvClfrProfileNodeAction is SetPrio or RetagPrio then this field
is used to specify the priority which is to be assigned to the packet.
If the
gsvClfrProfileNodeAction is MatchInGenList then this field is not
valid. If the gsvClfrProfileNodeAction is Count then this field is
read only and specifies total number of octets of the packets
hitting this node.
Type: Create -- Optional
Default value: ---
valend <valend-val> For Linear nodes this field is used to specify the end
of the range. If the gsvClfrProfileNodeAction is
InRange then this field is used to specify the end of
the range. If the gsvClfrProfileNodeAction is count
then this field is used to specify the total number of
packet hitting this node. For other actions this field is not valid.
Type: Create -- Optional
Default value: -----
sbasetype Abs | Add |
Compute |
This field is valid only for the SET_BASE action type. It is used to
specify, whether the base off set is to be set to an absolute value,