Planet Technology IP DSLAM IDL-4801 - Manual (Page 279)

IP DSLAM 279
PM Conf PMSF : idleop
Line DELT Conf LDSF : inhibit
Curr Output Pwr(dBm/10) : 10 DS Bin SNR Update :
Enable
Bin Number SNR Margin/bin
---------------------------------
[ 0] 16
Oper Status : Up Admin Status :
Enable
Output Fields:
FIELD Description
IfName The interface name of the DSL port.
Line Type Line type used by the DSL port.
Coding Type Line coding type used by the port.
GsUtopia L2TxAddr UTOPIA Level 2 Tx address for a line.
GsUtopia L2RxAddr UTOPIA Level 2 Rx address.
GsUtopia L2RxAddr2nd Conexant parameter to set UTOPIA Level 2 Rx address for the
secondary bearer channel in case of Dual Latency. (length = 4
bytes)
GsUtopia
L2TxAddr2nd
Conexant parameter to set UTOPIA Level 2 Tx address for the
secondary bearer channel in case of Dual Latency. (length = 4
bytes)
Gs Clock Type Indicates use of crystal or oscillator.
Gs Action Allows action on per-line basis.
Trans Atuc Cap Transmission modes that ATU-C is capable of.
Trans Atuc Actual Transmission modes
Trans Atuc Config The transmission modes that the ATU-C is capable of supporting.
The modes available are limited by the design of the equipment.
REFERENCE"Section 7.3.2 ITU G.997.1" (length = 4 bytes).
GsDmtTrellis Indicates whether trellis coding has been enabled or not.
Trans Atur Cap The transmission modes that the ATU-R is capable of supporting.
The modes available are limited by the design of the equipment
(length = 4 bytes).
PM Conf PMSF PM-related parameter used by ATU-C to force a change in the
line state. (Not available for ADSL/ADSL2Plus)
Line DELT Conf LDSF The DELT-related parameter used by ATU-C to force the line into
the loop diagnostics mode. (Not available for ADSL and
ADSL2plus)