Planet Technology IP DSLAM IDL-4801 User Manual

Page 321

Advertising
background image

IP DSLAM

321

Duplex auto|half|full

This parameter defines the modes, in which the Ethernet Interface can

come up. It can be configured as ‘auto’, ‘half’, ‘full duplex’ or a

combination of these. Based on the values configured, the Ethernet

interface negotiates with the peer entity.

Type : optional

Valid values: auto, half, full

Default value: auto

Pkttype

Mcast|Bcast|UnknownUc

ast | All|None

This parameter defines the packet type supported by the interface.

‘etherPktTypeSupported’ shall be configured for every Ethernet

interface. By default, all packets will be transmitted. The interface shall

not transmit any other packet type than that configured.

Type: Create - optional

Modify - optional

Valid values : Mcast, Ucast, UnknownUcast, All

Default Value: All

Orl decvalue

This parameter specifies the output rate limiting value to be applied on

this Interface. The unit for the same is in Mbits/sec.

Type: Create - Optional

Modify - Optional

Valid Values: 1 -100

Default Value: 100

ProfileName

<profilename-val>

This parameter specifies the scheduling profile to be associated with the

Ethernet interface.

Type : Optional.

Default Value : SPROFILE

mgmtvlanid

<mgmtvlanid>

This parameter specifies the VLAN (C-Vlan) for management traffic on

this interface. Non-zero value of this field is valid only if either 'ip' field is

non-zero or 'usedhcp' field is true. If no Management VLAN id is

specified (in the create operation) or its value is set to zero (either in

create or modify operation), then the system shall use the value of

'portvlanid' associated with the bridge port created on this interface as

the Management VLAN Index. In case the management VLAN (i.e.

'mgmtvlanid' or the associated 'portvlanid', if 'mgmtvlanid' is zero) does

not exist on the system, then IP-based management on this

management VLAN shall not happen on the interface till the

corresponding VLAN is created with the Net-side port as its member. In

stacked-VLAN mode, the VLAN filtering mentioned above is based on

virtual-VLAN mapped to C-Vlan and S-Vlan for the frame.

Type : Create - optional

Modify - optional

Valid values: 0 -4095

Advertising
This manual is related to the following products: